Gossen R2600 User Manual download pdf (Page 25)

GOSSEN METRAWATT GMBH 25

03h Second set point ± 15 bits (4.1.2) SP L ... SP H

04h High limit for relay A2 ± 15 bits (4.1.2) Same as PI = 01h Same as PI = 01h

05h Low limit for relay A2 ± 15 bits (4.1.2) Same as PI = 01h Same as PI = 01h

06h Low set point ± 15 bits (4.1.2) X1 ... SP H For fixed value controller,

slave controller

–MBU/2 ... SP H For differential controller

07h High set point ± 15 bits (4.1.2) SP L ... X2 For fixed value controller,

slave controller

SP L ... MBU/2 For differential controller

08h Lower range limit standard signal ± 15 bits –1500 ... rn H For B2, B4, B5

09h Upper limit standard signal ± 15 bits rn L....9999 For B2, B4, B5

0Ch Calibration actual value ± 15 bits (4.1.2) –MBU/4 ... +MBU/4 For B1, B3, B4 and TC

–MBU/4 = Auto,

–MBU/4 + 1 ... MBU/4

For B1, B3, B4 and Pt100

0Dh Location of decimal point 8 bits

0, 1 = 9.999, 2 = 99.99,

3 = 999.9, 4 = none

For B2, B5

0Eh Ramp for rising set points ± 15 bits

0 = oFF, 1 ... MBU

0Fh Ramp for falling set points ± 15 bits

0 = oFF, 1 ... MBU

1) The decimal point is for the display on the R2600/01 only, not for the parameter values.

2) Unit per minute, see 4.1.2 for units

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 39 40

No comments

Gossen R2600 User Manual Page 25