Gossen IPP 144 - 40 GE User Manual download pdf (Page 16)

Slide snap lock to the right hand side, swivel front door out.

Now you can see the switch S 101 on the printed circuit

board.

- For RS 232 C, RS 422 and RS 485 set switch S 101

to the right hand side.

- For Current loop, set switch S 101 to the left hand

side.

IMPORTANT:

This switching only applies to interface I.

If the printer is connected to the sender device

(e.g. to a PLC) the interface parameters must be

matched to those at the sender device.

See chapter 6.2. which describes the setting of

the baudrate, data format, stop bit and parity bit.

4.2. Interface selection (Interface I)

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 63 64

No comments

Gossen IPP 144 - 40 GE User Manual Page 16